How to Save Money on Bathroom Renovation

Bathroom remodels run the risk of emptying your wallet. Here is how to save money by nipping problems in the bud.

Each item is a potential problem that typically drives up costs.  Following each item is a suggested solution.

 

1.  Size of the bathroom will change

Solution: Resize only if absolutely necessary to accommodate your needs. This is the single most expensive aspect of the bathroom renovation; avoid at all costs.

The reason is because plumbing–particularly the toilet discharge and sewer pipe–are expensive to move.

 

2.  Load-bearing walls must be removed or moved

Solution: Explore possibilities of expanding through non load-bearing walls–walls that do not bear weight.  These walls can easily be removed using simple hand tools.  Often, no permits are required for this.  As a rule of thumb, exterior walls tend to be load bearing.  Interior walls that run parallel to ceiling joists tend to be non load-bearing.

If you do want to move that load-bearing wall, it is possible to do on your own.  Materials do not cost a lot.  Mainly, you need to correctly calculate the load and purchase a beam suitable for carrying the load.

 

3.  Walls cannot support additions of new vents, ducts, wiring, windows

Solution: Walls do not necessarily have to be totally replaced to accept these additions. Bad studs can be sistered to increase their load-bearing capacity.

  Raise this issue again with your contractor or seek a second opinion.

4.  Drywall is water-damaged; needs full replacement

Solution: Drywall often must be completely replaced in bathroom renovations due to the high moisture content; this is common enough and should be anticipated. Confirm with your contractor that full replacement is needed.

  It’s possible that only the affected areas need to be replaced.

5.  Sink, tub, and shower fixtures to be removed and replaced with new ones

Solution: Do they functionally need to be replaced or just aesthetically? They may be ugly but operable, and can be replaced easily by yourself at a later time. If that fails, buy on your own and supply to contractor. Or instead of replacing, you can install a liner over your tub or shower. If you don’t like the idea of a liner, you can always refinish your bathtub.